Getting Down To Basics with Cutting
Guide to Waterjet Cutting and Its Benefits Waterjet cutting was used largely in the 1950s to cut lumber from large trees. Today, because of advancements and improvements made on waterjet cutting methods, it can now be used for cutting any flat materials including stainless steel and aluminum. In order to cut or clean materials, a waterjet uses a high pressure stream of water. The waterjet is usually connected to a high-pressure water pump which releases water from a nozzle which then cuts through the materials at high speed. Putting additives in the form of abrasives helps in the cutting process. Using waterjet cutting has many benefits including some of those given below.
Why No One Talks About Cutting Anymore
One of the benefits of using waterjets is that it is very powerful. If you don’t expect waterjet to be that powerful just imagine that it can cut through eight inches of stainless steel plate and 10 inches of aluminum plates.
What Research About Waterjet Can Teach You
Waterjet cutting is the best method to cut materials that are sensitive to high temperatures such as that generated by using other methods. This is because there is no heat-affected zone and so it minimizes the effect of heat which allows metal to be cut without altering or damaging the surface of the material being cut. Waterjet cutting is precision cutting. They are capable of attaining an accuracy of 0.13 mm and repeatability of 0.03 mm. Using waterjet method of cutting gives you a burr-free finish aside from its precision cutting especially for steel and aluminum. This can save you a lot of money since it eliminates secondary surface finishing in most cases. You benefit from waterjet cutting since it is very fast to cut. Projects using waterjet method can benefit from its speed and efficiency. The reason for the speed is because it is easy to set-up, it is a very fast cutting process compared to other methods, and you don’t need to re-cut because of its precision. Waterjet cutting is an example of green technology. When the method of waterjet cutting is used, there are no hazardous waste materials produced. With waterjet cutting you can cut large pieces of reusable scrap material so it prevents unnecessary waste of resources which cannot be done with traditional cutting methods. There are more environmental advantages when you use waterjet cutting for your steel or aluminum. The amount of water used in waterjet cutting is very little. Every minute, you only use one half to one gallon of water. The size of the cutting head orifice determines the amount of water used. You can also recycle the water that is used using a closed looped system. The waste water is filtered and disposed through a drain which is clean enough to reuse. Waterjet removes airborne dust particles, smoke, fumes, and contaminants from cutting materials. This greatly improves the working environment and reduces problems arising from the machine operator’s exposure.The working environment is then improved greatly and the machine operator will have reduced problems from exposure.